[MI; MB] Pre Emotiva USP-1

Vendo coppia pre dell’americana Emotiva, brand che fa solo vendita diretta (acquistato e importato direttamente dagli USA a Gennaio 2014) dopo aver letto parecchie recensioni ottime che evidenziano la solidità (un esempio, forse banale ma significativo, è il comando remoto in robusto metallo) ed il rapporto qualità prezzo eccezionale.

Confermo assolutamente!

Io ascolto diversi generi di musica (vecchio rock, metal, hip hop, jazz, classica, blues, d'n'b...) da sorgenti differenti (vinile, musica liquida da notebook via DAC, radio e ovviamente CD).


Qualsiasi prova.

Manuali e cavi inclusi. Copia dell'odine di acquisto disponibile.


Vendo a 420 euro.
Ritiro di persona, o spedizione a parte

disponibile per qualsiasi prova.



Emotiva USP-1 Pre-amplificatore

- Design: Solid-State Stereo Preamplifier
- Inputs: 5 Pairs RCA Unbalanced, Tape Monitor, HT
- Maximum Power Output: 9 Volts RMS
- THD+N: 0.005%
- Weight: 14 Pounds

PHONO INPUT Section (clockwise from top left)
Phono Ground
Left and Right channel RCA inputs
MC/MM Switch. Use this switch to select your cartridge type. MC for Moving Coil or MM for Moving Magnet.

AUDIO Section
CD player inputs
Tuner inputs
2 x Aux – Suitable to connect to any audio device with Left and Right analog outputs.

TAPE INPUT/OUTPUT
A tape loop is provided for recording 2-channel source material from a Cassette, DAT or a Hard Disk Audio device with analog outputs.

HT INPUT (Home Theater) Allows the USP-1 to connect to an external multi-channel/home theater processor. This connection is disengaged when the USP-1 is in normal mode, but becomes active when the HT BYPASS button is selected on either the USP-1 front panel or remote control. In HT BYPASS mode, this connection becomes active and the USP-1 becomes a pass-through for the left, right, and subwoofer channels. This is a true ‘straight wire’ pass-through – what comes in is what goes out. This signal is sent into the HT Inputs (L,R, Sub), and is only present on the High Pass and Subwoofer Outputs.
ALL USP-1 functions become disabled in HT BYPASS mode, allowing the external processor to control volume, EQ, etc. 12

AUDIO OUTPUT SECTION
Low Pass Filter Frequency Control Rotary knob for selecting the low pass frequency, which can be set from 50Hz to 250Hz, with a slope fixed at 12dB/Octave.
Balanced Subwoofer Output
Balanced (XLR) subwoofer connection, with low pass frequency controlled by the rotary knob directly above it (6.).
RCA Subwoofer Output
Standard RCA subwoofer connection, with low pass frequency controlled by the rotary knob directly above it (6.).
High Pass Filter Frequency Control Rotary knob for selecting the high pass frequency, which can be set from 50Hz to 250Hz, with a slope fixed at 12dB/Octave.
High Pass RCA Outputs
Standard RCA connections for left and right speakers when being used with the High Pass filter.
Full Range Outputs These RCA outputs are 5Hz 5Hz - 80kHz, with less than 0.05dB of deviation. These outputs are unaffected by the High Pass or Low Pass filters.

ciao, vendi anche separati? mi interesserebbe il pre.

Ciao,
Ovviamente mi e' più difficile vendere separatamente i 2 pezzi ma possiamo parlarne.
Se vuoi mandarmi un proposta in pm, ne parliamo
Ciao
Paolo

-

-

Per ora vendo il solo pre

Pre ridotto a 380€
In coppia con finale XPA-200 a 750€ spediti

Ciao

Venduti. Grazie